6.8 Defining Custom Authentication Types

The are three ways to define custom authentication types:

1. Write a PAM module.
2. Use a Guile procedure.
3. Use an external program

You can write a PAM module implementing the new authentication type. Then, specifying Auth-Type = PAM allows to apply it (see section PAM Authentication Type).

Alternatively, you may write a Scheme procedure implementing the new authentication type. To apply it, use Scheme-Procedure attribute in RHS. The Auth-Type = Accept can be used in LHS if the whole authentication burden is to be passed to the Scheme procedure. For example, if one wrote a procedure my-auth, to apply it to all users, one will place the following profile in his ‘users’ file:

DEFAULT  Auth-Type = Accept
         Scheme-Procedure = "my-auth"

For a discussion of how to write Scheme authentication procedures, See section Authentication with Scheme.

The third way to implement your own authentication method is using an external program. This is less effective than the methods described above, but may be necessary sometimes. To invoke the program, use the following statement in the RHS of ‘users’ entry:

Exec-Program-Wait = "progname args"

The progname must be the full path to the program, args — any arguments it needs. The usual substitutions may be used in args to pass any request attributes to the program (see section Macro Substitution).

For a detailed description of Exec-Program-Wait attribute and an example of its use, see Exec-Program-Wait.

This document was generated by Sergey Poznyakoff on December, 6 2008 using texi2html 1.78.